Key Benefits
More Consistent Dome-Pressure Control
When you’re tuning boost with dome pressure, the Gen3 gate’s piston and O-ring design helps you keep control more consistent than a conventional diaphragm design.
Make Spring Changes Less of a Chore
The V-band head on this wastegate makes spring changes quicker, so adjusting your spring setup takes less time away from the rest of the build.
Materials Suited to the Hot Side
A cast stainless-steel body and Inconel valve give our VS Racing gate materials suited to the heat of a turbo exhaust system. An alloy head completes the assembly.
Product Overview
Our VS Racing Gen3 44 MM External Wastegate gives your external-wastegate turbo setup a piston and O-ring design for consistent dome-pressure control, with a V-band head that makes spring changes quicker. The 4 PSI and 6 PSI springs are already fitted, giving a combined 10 PSI spring setup out of the box. Match the gate size, mounting and control connections to your installation.
Installation note: Always install the fire ring at the base of the gate. Omitting it can cause a leak between the V-band and wastegate flange.
See the Fitment Guide and Product Specifications for more details.
Product Specifications44 MM · Piston and O-ring
Technical Specifications
- Size
- 44 MM
- Construction
- Cast stainless-steel bodyInconel valveAlloy head
- Control Design
- Piston and O-ring
- Installed Springs
- 4 PSI + 6 PSI pre-installed10 PSI combined
- Control Ports
- 2 upper air ports2 lower air ports
Fitment GuideTurbo systems using an external wastegate
- Turbo systems using an external wastegate
Match this 44 MM gate to your wastegate mounting, flanges and boost-control layout, and check installation clearance. Application depends on the turbo system and installation, rather than the vehicle name alone.
What’s in the Box?1 × VS Racing Gen3 external wastegate
- 1 × VS Racing Gen3 external wastegate
- Included
- 2 × pre-installed springs (4 PSI + 6 PSI)
- Included
Common Questions2 questions
How do I connect the ports for spring-pressure control?
Connect the pressure source, usually from the turbo, to one lower port and cap the other lower port. Leave one upper port vented and cap the other upper port.
How do I connect an electronic or dome-pressure setup?
Tee the pressure supply to one lower port and the solenoid input, and cap the other lower port. Connect the solenoid output to one upper port. Cap the other upper port unless it is used for a dome-pressure sensor.






